Do you know what major care you need to have when installing a split air conditioner?

Although it seems simple, the accommodation of an air conditioner of this model is quite complicated, especially for those who understand little of the subject. If you are installing a split air conditioner without paying attention to where it will be placed, or even without performing the thermal calculation of the environment that will accommodate it, you need help. We’ve brought you six tips that will definitely help you when you install a split air conditioner.

Calculate the required cooling power

The first task you must perform before installing a split air conditioner is to calculate the cooling capacity required to air-condition the room. To do this calculation, you need to measure the area of ​​the environment and check if it receives sunshine in the morning or afternoon. Thus, you will be able to know the amount of BTUs (British thermal unit), that is, the cooling power that the air conditioner must have to cool the environment properly. There are several calculators on the internet where you inform the size of the environment and the website shows you the power of the indicated air conditioner. To know more about Air conditioning installation Geelong, one can seek help from the internet.

Find the best location for the installation

The split type appliances have this name because they are divided into two parts: the evaporator, which is inside the house, and the condenser, which is outside. Both need to be installed in proper locations so that they can function perfectly. In the case of the evaporator, it is recommended that it be installed in a centralized location that does not have obstacles that could impede the escape of air. The condenser should be positioned in an airy, ventilated area that, if possible, does not have direct contact with the sun. If you install in a place with a lot of sunshine, an air-conditioning protector can reduce the damage to your air conditioner.

Drill a suitable hole for drain passage

The split air conditioner has a drain that is responsible for channeling the condensed water that flows constantly from the equipment. Because they do not give the necessary attention at the time of their installation, many installers usually leave the drain with a certain elevation or curved near the exit of water, which ends up making it difficult to exit. As a result, the condensed water eventually falls into the environment. The correct thing is to make a slightly inclined hole in the wall so that the water outlet is facilitated.

Choose a correct voltage outlet

The device must be connected to a specific circuit breaker with wiring unique to it. In the case of two or more conditioned airs, a circuit breaker will be required for each. If there is an exclusive outlet and the connection has been improvised, the household power grid may be overloaded and the life of the appliance compromised. Remember that the split air conditioner needs to be plugged into a 220V electrical outlet. If you try to connect it to a common 110V, it certainly will not work.

Be aware of the quality of thermal insulation

Air conditioners rely on thermally insulated copper pipes, which conduct coolant air between the condenser and evaporator units. The thermal insulation should consist of elastomeric foam, which prevents some problems such as heat gain in copper pipes and low material throughput due to dust, cement, gypsum and ultraviolet (Ultra Violet) rays. When the thermal insulation is of quality, the device works perfectly and consumes less energy.

Plan the installation of multiple condenser units

Planning should be stepped up when you are called to install multiple appliances in commercial or residential buildings. This is because, as the conditioned air will be very close to one another in the same environment, it is essential that they have similar comfort conditions, with the air being evenly distributed. In this case, the distance between one condenser and another and the number of walls that are blocking the front of the external units must be analyzed.

Comments are closed.

  • Partner links